First, when the unpacking machine is working, the rising cylinder of the lower solid box does not move or the action is very slow?
Solution: need to speed up the cylinder regulating valve, if not, need to replace the solenoid valve.
Second, the suction cup failure, suction cup damage or insufficient air pressure?
Solution: Replace the new product or adjust the air pressure.
3. Is the tape device abnormal?
1, tape cut constantly.
Solution: The blade is not sharp or the tape film is stuck. Replace the blade, clean the blade, and grease the blade.
2, the tape has been cut off but drag a section.
Solution: The knife seat is stuck, the action is not flexible or the spring is not tight enough, check the screws in each part of the tape attachment, or adjust the spring spring.
3. The tape is cut off but does not fit the surface of the box.
Solution: the main spring is too loose, the rear wheel rebound speed can not match the speed of the belt, and the main spring screw is properly locked.
4. The carton is stuck in the middle.
Solution: the main pull spring is too tight, the front wheel is trapped in the middle, moderately relax the tape wheel main pull spring.
5, the tape is easy to fall off.
Solution: one-way roller loses effectiveness, replace the new one-way roller.
The above is about the automatic unpacking machine common faults and solutions, our automatic unpacking machine is equipped with a shortage of materials in advance alarm, no material automatic shutdown safety device, greatly convenient operation, management, reduce production personnel and labor intensity, is an essential equipment for automatic large-scale production.